Jura Impressa
5articles tagged with this topic

Jura C60 Loud Noise at Switch-Off: Brew Unit Strains and the Drip Tray Gets Pushed Out
Your Impressa C60 makes a loud straining noise when it switches off, the drip tray moves out, and the machine goes back to HEATING. Here is what that pattern can mean, the safe checks to do first, and when to stop.

Jura XJ9 Leaking After Descaling, Even With a New Brew Unit
Your Impressa XJ9 has a new brew unit, then it leaks after a descale. A new brew unit does not renew every seal. Separate normal descaling water from a leak, note when the water appears, and check the parts the rebuild touched.

Jura Error 4: Steam Temperature Sensor Above Range (S, X, Z Models)
Jura Error 4 means the steam temperature sensor reported a value above its allowed range. The machine stops the steam side for safety. The cause is a machine that is too cold, or a failed steam sensor, thermal fuse, heater, or board.

Jura Impressa Grinder Runs but No Beans Feed: C60 Diagnosis
If an Impressa C60 grinder motor runs but beans do not feed, check the gate, bridging, burr inlet and drive coupling in this safe diagnostic order.

Jura Error 3: Steam Thermoblock Sensor Fault Explained (S, J, Z, X Models)
Jura Error 3 is a steam temperature sensor fault. It only appears on machines with a second thermoblock for steam: the Impressa S, X, and Z lines, the X8, and the Z8. Here is what it means, why the E8 never shows it, and what the repair costs.